Rorke Data The Galaxy 65 Spécifications Page 30
- Page / 100
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Galaxy GHDX-2422S-8+12F4D Installation and Hardware Reference Manual
Safety Precautions
2-2
SFP transceivers: If the FC cables that were previously purchased do not come
with pre-installed SFP transceivers, SFP transceivers with LC-type, multi-mode
cables must be separately purchased. (See Section 4.2.3)
(2). One (1) audio-jack-to-DB9 cable is provided to facilitate the connection of the
COM1 port for local terminal emulation access to the array.
(3). Two (2) power cords are provided for the power connections to the power
sources.
(4). The RJ-45 Ethernet cable for network management connection is a user-supplied
item.
5. Memory modules: If you wish to change the pre-installed memory modules, the
separately purchased modules must be installed. Please contact your vendor for a
different memory module or consult the list of compatible modules.
6. BBU module: If you wish to use a BBU module, the module can be purchased
separately.
7. Rack installation: The enclosure chassis can be installed into a rack cabinet using
self-purchased mounting rails, or Galaxy’s GAL-9272CEslide28 or GAL-
9272CEslide36 mounting rails. A printed copy of installation guide is provided with
the slide rail packages.
2.3 Safety Precautions
2.3.1 Precautions and Instructions
1. Be sure the correct power range (100~120 or 220~240VAC) is supplied by your
rack cabinet, UPS device, or power outlet.
2. Thermal notice: All drive trays (even if they do not contain a hard drive) must be
installed into the enclosure. Leaving a drive bay or module slot open will greatly
affect the efficiency of airflow within the enclosure, and will consequently lead to
system overheating. Keep a faulty module in place until you have a replacement unit
and you are ready to replace it.
3. An enclosure without disk drives can weigh up to 24 kilograms. Two (2) people will
be required to install or relocate the subsystem. Drives should be removed from the
enclosure before moving the subsystem.
4. Airflow considerations: The subsystem requires an airflow clearance especially on
the front and on the rear. A minimum of 2.5cm is required between the front of the
- Galaxy Raid 1
- Installation and Hardware 1
- Reference Manual 1
- Contact Information 2
- Copyright 2006 3
- Warnings and Certifications 4
- (Certified Worldwide) 5
- CNS 13438 (for Taiwan) 5
- Table of Contents 6
- APPENDIX A SPECIFICATIONS 8
- APPENDIX C PINOUTS 8
- Safety Precautions 9
- About This Manual 9
- Revision History 10
- Who should read this manual? 10
- Conventions 10
- Warnings 11
- Cautions 11
- Chapter 1 13
- Introduction 13
- 1.1.2 Model Variations 14
- 1.1.3 Enclosure Chassis 14
- 1.1.3.1 Chassis Overview 14
- CAUTION! 16
- 1.1.3.2 Physical Dimensions 16
- 1.1.3.5 Rear Panel Overview 18
- 1.2. Subsystem Components 19
- WARNING! 21
- DIMM Module 23
- 1.2.4 Optional BBU Module 23
- 1.2.5 Power Supply Units 24
- 1.3. Subsystem Monitoring 26
- 1.4.3 Normalized Airflow 28
- Chapter 2 29
- Hardware Installation 29
- 2.3 Safety Precautions 30
- 2.5 Unpacking the Subsystem 34
- 2.6 Installation Overview 35
- 2.7 Rackmounting 36
- Figure 2-4: Front Ear Holes 37
- 2.8 BBU Installation 38
- IMPORTANT! 39
- 2.9 Hard Drive Installation 40
- 2.9.3 Drive Installation 41
- 2.10 Drive Tray Installation 42
- Chapter 3 45
- Subsystem Monitoring 45
- 3.2 Status-indicating LEDs 47
- 3.2.3 LAN Port LEDs 49
- 3.2.4 LCD Keypad Panel 50
- 3.2.5 Drive Tray LEDs 51
- 3.2.6 PSU Module LED 51
- 3.2.7 Cooling Module LED 52
- 3.2.8 BBU Module LED 53
- 3.3 Audible Alarm 54
- C Monitoring 55
- This page is intentionally 56
- Chapter 4 57
- Subsystem Connection and 57
- Operation 57
- 4.1.3 SFP Transceivers 58
- 4.1.5 Points of Failure 59
- 4.2 Power On 62
- 4.2.3 Power On Enclosure 63
- 4.2.4 Power On Status Check 63
- 4.2.5 LCD Screen 64
- GALAXYHD 64
- 4.3 Power Off Procedure 65
- Subsystem Maintenance and 67
- Upgrading 67
- 5.2.1 Overview 69
- NOTE: 73
- 5.4. Replacing a Faulty BBU 74
- 5.7. Drive Tray Maintenance 81
- Appendix A 87
- Specifications 87
- Configuration 89
- Architecture 89
- A.6 RAID Management 91
- Appendix B 93
- Spare Parts and Accessories 93
- Controller Modules 94
- Accessories Overview 94
- Appendix C 97
- Pinouts 97
- C.3. GAL-9011 Null Modem 100
- C.4. Ethernet Port Pinouts 100
- C.5. Main Power 100
Produits connexes et manuels pour Réseaux de disques Rorke Data The Galaxy 65
(129 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.076 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels